Actions always disabled on MAC AP

[booross]

I have AP loaded, MAC version 3.6 build 117, and when I'm in presentation mode none of my actions are enabled. The blue arrow shows when I hover over something, however when I click on it the white pick-up handles show up and no action plays. (I am definately sure of being in presentation mode - design mode works as normal).
I have unloaded and reloaded the software and the same problem exists. (I am using the new dvd disc.) I am also running dual platforms on my MAC. My MAC Activstudio software runs perfectly on my same MacBook laptop and both AP and AS run perfectly on the windows side. ????

[rae13]

Yes, it is infuriating!!!
I usually make my flipcharts on PC but when i go to use them on Mac, actions don't work. if i download flipcharts from the Planet, they work on PC, but not when i need them on Mac at work.The one that annoys me most is the page reset - I would use that a lot, mostly greyed out - end up closing and re-opening flipchart, except for the times it takes me by surprise and actually works.
It's supposed to be a bug in the software - so I've been told.

[LisaD]

That's really strange. I use a mac and my actions work like they should. I even tried with Activprimary.

Quick question. Do the actions work WITHOUT the board, like directly on your computer? I remember once that my actions would work sporatically when I was using them at the board but if I clicked with my mouse they would work.

This may be a question for tech support.

Lisa

[trombba]

Try resetting your preferences. That worked for me. (Check the thread, actions mysteriously disabled.)